Electrical Engineering - Project Reports

Permanent URI for this collection

http://aiktc.ndl.gov.in/handle/123456789/3442

Browse

Browsing Electrical Engineering - Project Reports by Author "Amin, Shraddha"

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    John Bedini's free energy generator
    (AIKTC, 2018-05) Amin, Shraddha; Naik, Saif Ali (15DEE02); Waghu, Faizan (15DEE07); Sayed, Aquib (15DEE13); Naik, Asif (15DEE17)
    The main aim of the project is to Generate electricity without using any fuel. Actually, "electrical science" is well aware of the little voltage spike that appears in a circuit when an energized coil of wire is disconnected from its source of current. This phenomena is generally considered to be: 1) a nuisance that 2) can damage electronic components in the circuit 3) unless it is gotten rid of somehow. 4) It is also generally believed to have no significant amount of energy associated with it, other than the "over-voltage" condition it may momentarily produce. In this project, we will consider this little voltage spike to be: 1) of the highest importance to understand 2) and to take advantage of it 3) for the recovery of its real, yet under-appreciated, energy content. In this project we will be using an electronic circuit having resistor diode and transistor Network to utilize that voltage spike to charge a battery.
  • Thumbnail Image
    Item
    Self generating electric bicycle
    (AIKTC, 2018-05) Amin, Shraddha; Khan, Abu Suffiyan (15DEE06); Shaikh, Muzammil (15DEE29); Khan, Danish (15DEE05); Shaikh, Farhan (15DEE33)
    The main aim of the project is to control reduction in natural fuel and make the environment pollution free by using self generating electric bicycle. This is an advanced technology in the automobile. Now a day automobile industries are growing faster and they are launching new new cars every day for the users which runs on fuel and making environment polluted. So to make the environment pollution free and to save the fuel for the next generation the self generating electric bicycle should be adopted by automobile industries. In self generating electric bicycle the supply is fed to the hub motor of 250 watt 24 volt which is in front wheel of a cycle by a 1st set of battery each of 12 volt 12 amp at the same time back wheel is having hub motor which is of 500 watt it rotates due to inertia of front motor with a small electronic circuit the back wheel hub motor act as a generator and charges the 2nd battery bank which is of same rating as 1st battery bank. When 1st battery bank gets drains out it gets shown on indicator which shifts the battery bank 1st to get charge by back hub motor and 2nd bank to supply the front hub motor. The speed control and indication is done by a controller which perform certain task when they required